Some tracing or testing would be necessary. In other words, if the hot line that provides power to the light (or whatever the switch powers) goes into the light fixture first and then into the light switch box, you won’t be able to use a switch/outlet combo.
Changing a light socket to an outlet or plug.
How to change an outlet to a light fixture. You probably have a single gang rectangular box. Received 14 votes on 12 posts. If you can't get the adapter plate to work with the single gang box easiest is to replace the box with a 3 or 4 octagon or round old work box.
I have installed the light fixture in the ceiling and have run a 2 conductor cable in the attic from the light fixture to the switch. At this point i am confused as to complete the wiring of the switch and the receptacle. Any help would be greatly appreciated.
Holiday and outdoor party lighting can quickly take up any outdoor outlets you have around your home. Update a closet wall light with a switched corded overhead light. Using a light bulb socket to outlet adapter.
Always use multiple sources and do your homework before performing any electrical work. In a properly wired situation where there is no power “on” to anything in the room, the white wire could be accidentally touched without receiving a shock. At the switch box the white neutral wires are spliced together, and the ground wires are spliced and a pigtail wire is added and attached to the green ground screw on the light switch frame.
The light probably came with an adapter plate. How to turn a light fixture socket into an outlet. Replace light fixture with switched outlet:
Could be that the switch and/or home run (source) wires come into that box, and that two pairs go out to the other light boxes. Has a 2 conductor cable coming into the switch box. Changing out a bulb socket for an electrical outlet.
This setup is how our master bedroom was wired before i installed an overhead ceiling fan. How to use a light bulb socket adapter. As promised, i detail below how to modify this wiring setup with minimal effort so that the switch can instead control an overhead fixture.
There are adaptors which you can screw in and allow you to connect an extension cable. The sconce may be intended to fit in an octagon box. Light wiring is no different than outlet wiring in terms of capacity.
The power must be coming into the light switch box first, and then continue on to the light fixture. The breaker should already be sized appropriately. A year later these came out and i think they are a way better solution.
Last week i described how an outlet should be wired for switch control when the voltage enters the circuit at the outlet. Also, make sure all work is done within national and local code. The incoming power from the outlet is attached to one of the light switch screw terminals and the black wire of the cable leading to the light fixture is.
The black wire sends the electrical current to the outlets or light fixtures and the white wire is neutral and returns the current to the electric panel.